Knowledge

Display Manual

Posted by Senquan

June 28, 2025

On June 28, 2025

This instruction manual applies to the battery Intelligenc Display and Handlebar Display.

Button Operations

Power on/off

Hold middle button for 3 seconds

Turn on/off backlight and headlight

Hold + button for 3 seconds

Walking mode

Hold – button , release button to quit walking mode

Assist level

Press + or – button to change assist level

Display mode(only for Handlebar Display)

Press middle button to switch

ODO：Total distance

TRIP：Trip distance

TM：Driving duration

ERR：Error code

Setting mode

Turn on the display, hold both + and – buttons for 3 seconds, then enter password 109 or 1009 to enter/quit the setting mode.

For Handlebar Display, press mid-button, switch setting parameters：P01-P20, press + or -button to adjust parameters value.

For Intellegence Display of battery, press + or – to switch setting parameters: P01-P20, press mid-button to enter parameter, then press + or – button to adjust parameters value, press mid-button to exit parameter.

Parameter	Description	Range	Default	Marks
P01	Backlight brightness	1-3	2	1 darkest,3 brightest
P02	Unit of speed	0-1	0	0 for KM/H，1 for MPH
P03	Rated voltage	24, 36, 48	36	Unit: V
P04	Automatic shutdown	0-60	5	Unit: minute. 0 for never shutdown
P05	PAS level mode	3, 5, 9	5	Intelligenc Display of battery fixed to 5 levels
P06	Wheel diameter	4.0-30.0	28.0	Unit: inch
P07	Speed magnets	0-20	6
P08	Speed limit	6-100	25	Unit: KM/H
P09	Zero start mode	0-1	0	The zero-start mode refers to whether the motor can start from a speed of 0. 0 for zero start,1 for non-zero start
P10	Driving mode	0-2	2	for dual-drive systems only, 2：Drive both self and other devices, 1：Drive self only, 0：Drive other devices only
P11	Start angle	2-10	2	Refers to the number of magnet signals received before the motor starts.
P12	Start strength	0-5	0	Refers to the intensity of the motor at the moment of starting.
P13	Cadence magnets	0-15	12
P14	Current limit	5-15	10	Unit: A
P15	Low voltage	21.0, 30.0, 39.0	30.0	Refers to P03, non-modifiable
P16	Reset ODO			Hold + button for 5-10 seconds
P17	Reset display			Hold + button for 5-10 seconds
P18	RPM of motor	120-999	290	For 250W motor, RPM 290; For 350W motor, RPM 350; For 500W motor, RPM 450; For 250W-Brompton motor, RPM 350; For 350W-Brompton motor, RPM 400.
P19	Reserved parameter	0-2	0
P20	Cassette magnets	0-20	4	For the V1 version of the cassette sensor, the magnet number is 4. For the V2 version of the cassette sensor(under development), the magnet number is 8.